DEXA scan

Measures bone mineral density and can estimate lean mass, total body fat and fat distribution.

What it measures

A DEXA scan uses two low-dose X-ray beams to measure how much energy passes through different tissues in your body.

A standard bone-density scan usually examines the hip and spine. A full-body DEXA scan can also estimate lean mass, total body fat and how fat is distributed. The information available depends on the type of scan ordered and the software used by the imaging centre.

DEXA provides more detail than body weight alone. However, it does not measure muscle strength, physical fitness or organ health.

At a glance

Type
Low-dose X-ray
Duration
Usually 10 to 20 minutes while you lie still.
Radiation
Very low. A bone-density scan typically uses less than one-tenth of the radiation from a standard chest X-ray.

What it shows

  • Bone density: Measures bone mineral density, usually at the hip and spine. Depending on your age and clinical circumstances, the report may include a T-score, a Z-score or both. These results help assess osteoporosis and fracture risk.
  • Muscle mass: A full-body scan can estimate lean mass in your arms, legs and trunk. This may help identify low muscle mass, although sarcopenia cannot be diagnosed from DEXA alone. Muscle strength and physical function also need to be considered.
  • Fat, and where it sits: Estimates total body fat, regional fat distribution and, on supported machines, visceral fat around the abdominal organs.
  • Change over time: Repeat scans can help track changes in bone density, lean mass or body fat.

What it doesn't show

  • Why bone density is low: DEXA measures bone density but does not establish the cause of bone loss. Medical history and tests for factors such as vitamin D, calcium, thyroid function and sex hormones may help complete the picture.
  • Joints and arthritis: DEXA is not designed to assess cartilage, joint damage or common causes of knee and back pain. An X-ray, MRI or another test may be more appropriate after clinical review.
  • Muscle strength or quality: Lean mass is not the same as strength, mobility or physical performance. These require separate assessments.
  • Organ health: A DEXA scan does not diagnose liver fat or disease affecting internal organs. Depending on the question, an ultrasound, FibroScan, MRI or another investigation may be needed.
  • A precise visceral fat measurement: Visceral fat is an estimate and may vary between machines and software. It is more useful for tracking your own trend under consistent conditions than for comparing results from different centres.

Symptoms that warrant a scan

  • Loss of height, a more stooped posture or unexplained back pain that could indicate a vertebral fracture.
  • A fracture after a minor fall or injury.
  • Increasing weakness or difficulty with stairs, lifting or other everyday movements, particularly when low muscle mass is suspected.
  • Missed periods for three months or more outside pregnancy, or another reason to suspect prolonged low oestrogen.
  • Long-term use of medicines associated with bone loss, including steroid tablets.
  • A health condition, treatment history or family history that increases the risk of osteoporosis.
  • Concerns about changes in muscle or abdominal fat despite a stable weight, when measuring body composition would help guide care.

Blood results that warrant a scan

No single blood result automatically means that someone needs a DEXA scan. Results should be considered alongside age, menopause status, fracture history, medicines and other clinical risk factors.

  • Vitamin D: Persistently low vitamin D may contribute to poor bone mineralisation, especially when other bone-loss risk factors are present.
  • Oestradiol or testosterone: Low sex-hormone levels can accelerate bone loss. A DEXA scan may be considered when the result is persistent or accompanied by relevant symptoms or risk factors.
  • TSH: A persistently suppressed TSH, an overactive thyroid or excessive thyroid-hormone replacement can increase the risk of bone loss.
  • HbA1c: Diabetes and long-term poor glucose control can affect bone quality and fracture risk. A raised HbA1c does not automatically require DEXA, but it may contribute to the overall risk assessment.

How often

  • First test: A baseline scan from 35
  • Optimal: Every 5 years, or longer
  • Suboptimal: Every 2 to 3 years
  • Needs attention: Every 1 to 2 years
  • For muscle and fat tracking: Every 6 to 12 months

Preparation

  • Day before: Do not take calcium supplements for at least 24 hours before the scan, unless the imaging centre gives different instructions. Tell the centre if you recently had a test involving contrast material, barium or a radiopharmaceutical.
  • On the day: You can usually eat normally. Wear loose clothing without metal fasteners and remove jewellery or other metal objects. Tell the staff if you are or may be pregnant.

Systems this test informs

  • Musculoskeletal primary

    Bone mineral density at the hip and spine is the core readout, used to assess osteoporosis and fracture risk.

  • Metabolic secondary

    A full-body scan estimates total body fat, regional fat distribution and, on supported machines, visceral fat around the abdominal organs.

  • Endurance secondary

    Lean mass in the arms, legs and trunk can flag low muscle mass, although strength and physical function need separate assessment.

Sources